|
Pile Points for H Beams, I Beams & Timber Piles
REDUCE INSTALLATION COSTS OF TIMBER & H PILES, INCREASE PILE RELIABILITY
In these tight economic times with ever increasing labor, equipment
and materials costs, all available products and techniques must
be employed to reduce pile installation time and costs to insure
integrity of H and timber piles being driven.
H pile points provide protection for steel H beams and timber piles as well as marine and bridge piling during the installation process with its wide flange design. H pile points can be used on all H bearing pilings. MIDAMERICA
FOUNDATION CONSTRUCTION
offers a complete line of sheet piling accessories including H points,
boots, couplers, H splicers, endcaps, end plates, cutting rings and edge protectors
to help speed pile installation time and to help guarantee
the load bearing capacity of driven piles. And for a small
added investment in pile points or splicers it will be returned
several times over in reduced pile costs and/or reliability.
All
MIDAMERICA
FOUNDATION CONSTRUCTION
piling accessories are manufactured from high-strength materials
and are made in sizes to fit standard sizes and types of piles, including H and timber piles.
|
|
 |
H PILE POINTS FOR H BEAMS & I BEAMS
The load bearing capacity of driven steel H beams and I beams can be greatly reduced if the H piles are damaged during driving due to impact with rocks, boulders, rubble or other
obstructions. HMC H pile beam points provide pile tip for H piles or timber piles
to minimize this type of damage. HMC H pile and I beam points increase the bending
strength of pile flanges and web from 2 to 6 times thereby helping
insure that the pile reaches final bearing in position and in
good condition.
Made
of tough cast steel (ASTMA2765/35)
Maximum protection for critical outer corners of I beams
Wide surface to support a beam wide flange
Quick and easy to attach
Assures undamaged piles
Sizes available for all H-Beam sections
|
|
|
 |
ROCK-BITE POINTS FOR H BEAMS & I BEAMS
In response to market demand for
a reduction in H pile beam points and I beam points beyond our standard selections, HMC manufactures
the ROCK-BITE cast steel point. The ROCK-BITE point for H piles and I beams provides
added ability to push through obstructions and to set the pile
into harder bearing materials. ROCK-BITE teeth bite into sloping
bearing strata with both vertical and batter piles. ROCK-BITE points are available for all H pile and I beam sections.
Our I beam / H pile points have wide flanges and web for even greater protection than standard points.
Heavy stabbing H pile beam / I beam points are used for penetration on sloping surfaces.
Increased wide flange tip depth for added strength.
|
 |
POINTS FOR TIMBER PILES
If soil data indicates possible timber pile damage due to obstruction or a stiff layer which must be penetrated, MIDAMERICA FOUNDATION CONSTRUCTION points for timber piles provide the required assurance that the pile will reach bearing in good condition.
Points for timber piles prevent pile splitting and brooming.
Points for timber piles are available for all timber pile sizes.
Points for timber piles are made of ASTM A-36 steel plate.
|
|
MAFCO
Mid-America Foundation Supply, Inc.
PH:
888-893-7453
Fax: 260-424-8635
3101
New Haven Ave.
Fort Wayne, IN 46803
••••••••••••••

Poseidon Barge
Corp.
••••••••••••••

Enviro Media
Blasting
Low Dust Abrasive
Blasting Technology
••••••••••••••

Hercules Machinery Corp.
Manufacturer
and Supplier of Foundation Equipment.
|